charlottehomegaragedoors.com :: How to integrate Garage Door remote in car - Charlotte Home Garage Doors
Tap to Call Now!
Tap to Call Now!     (704)980-2919    (980)238-4342
World Class Service at Your Doorstep

Save Big with Exclusive Special Offers!

99
199
249
125
75
100
Half Price
200
99.95
89
149
World Class Service at Your Doorstep

Posted on 2016-01-30 by Author Admin

It is always critical to ensure that the garage door is secure, convenient and easy to access at all times. One of the best actions that an individual can undertake is integrating a garage door remote into the car. This garage door remote that facilitates the garage door opener to work efficiently can highly boost the garage door security.

Besides, it can enable the garage door to open and close in a simple and effective manner if the garage door rollers are efficiently working. In the case where the rollers may be hindering proper opening and closure of the garage door, one can undertake garage door roller replacement to facilitate proper functioning of garage door.

Here are the major steps involved in integrating the garage door remote:

Installing-Garage-Door-Opener-White-Garage

1. Assembing of tools and materials

For efficient integration, some tools and materials need to be used. They include:

Soldering iron

Small wires

Buttons

Garage door remote

2. Identifying the best location point

When establishing where to locate the garage door remote in the car, it would be critical to ensure that the place is secure and easily accessible. For instance, a good location point for the remote can be under a rear mirror that is well covered and can be reached without any sort of difficulty. The location should also be perfect to detect the radio frequencies that emanate from your garage door opener.

3. Installing the garage door remote

Once the outer plastic part of the garage door opener remote has been removed, it is crucial to identify the point where soldering will be performed. This soldering point should contain the button which will facilitate opening and closing of the garage door opener. The small wires should be soldered from the top side into the circuit board of the garage door remote. Meanwhile, the leads should be soldered from the back. Using a wire cutter, one can trim the elongated leads to the right size.

4. Place back the circuit of remote and switch button

After proper installation of the garage door essential parts, a small hole can be made on top of the circuit board where the button can be mounted. The wires can then be soldered to the button to make the entire connection complete.

5. Reassembling of the entire connection

Once the wires have been perfectly connected to the button, there is need to carry out a test to ensure that connection established is functioning properly. This could be done through testing the open and close button located in the garage door remote. Once it proves that it is efficiently operating, this implies that it is ready for use.

Proper maintenance of garage door remote

Once the garage door remote has been fully installed into the car, it would be critical to ensure that the garage door rollers and the garage door springs are intact and functioning well. If the tension springs are subjected to wear and tear, garage door springs replacement can be effective.

To ensure that there is continuous seamless integration of the garage door remote in the car, one should put into account proper maintenance and consistent functioning of the device. This will indeed boost its efficiency besides giving an individual ability to control his or her garage door.

We Service and Repair All Brands of Doors and Openers

allstar amarr chamberlain chi safe-way craftsman delden digi-code doorlink genie guardian haas-door liftmaster
linear marantec mid-america moore-o-matic multi-code northwest raynor safe-way sears skylink stanley udt wayne-dalton

Contact Info

Uptown, 401 North Tryon Street, 10th Floor
Charlotte , NC 28202

Call Now! (704)980-2919  (980)238-4342